Servo Garage Doors garage door team

Garage Door Opener Repair & Installation in Pasadena - Fixed Today, Priced Before We Start

Most garage door faults are fixed in a single visit. The common springs, cables and rollers are brought to the job, and you get the price before any work starts.

✓ Licensed & Insured ✓ Written quotes ✓ Permits handled
Call Now - 24/7 Dispatch

We answer around the clock

Work is performed by our local vetted partner.

Work is performed by our local vetted partner.

🛡 Licensed & Insured 📝 Written Fixed-Price Quotes 💲 No Change Orders · Free Estimates
Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

We have financing partners for your new garage door*on approved credit; ask us about your options

You get a price before we start. It does not change when the pro arrives.

Styles & brands we work with

Raised-panel steel
Raised-panel steel
Carriage house
Carriage house
Modern flush
Modern flush
Full-view glass
Full-view glass
LiftMaster openers
LiftMaster openers
Chamberlain openers
Chamberlain openers

Before & after – our own jobs

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Genie Roller Replacement: The Olympia Owner’s Guide

Genie roller replacement in Olympia runs $110-$220 installed, and we stock the common sizes on hand. Most Genie sectional door systems use 2-inch or 3-inch stem rollers, and we can match your exact spec from the door sticker or a quick measurement. Same-day service is available when you call (360) 995-1547.

Call (360) 995-1547

Most Olympia homeowners figure out their rollers are shot when the door starts sounding like it’s dragging a chain up the track, or when one side hangs lower than the other going into the open position. The roller is the small wheel assembly that rides inside the vertical and horizontal track, carrying the full door weight every cycle. When the bearings seize or the wheel cracks, the door strains the opener and the track geometry goes off.

Which Genie Models This Applies To

Genie doesn’t manufacture their own rollers. They source them for their complete door systems, which means the roller you need depends on the door model, not the opener hanging on the ceiling. Look for the door sticker, usually found on the interior face near the bottom section or on the end stile. Common Genie door series in Olympia include the Intellicore, Signature Series, and older QuietLift-compatible sectional doors.

The critical measurement is stem length. Most residential Genie doors use a 2-inch roller with a 4-inch stem, but heavier 2-inch or 3-inch doors, especially the insulated Intellicore models common in the newer Tumwater and Lacey builds, sometimes spec a 7-inch stem to clear thicker hinge offsets. We measure this on-site rather than guess from a model name. OEM rollers from Genie supply channels run nylon or steel; we also carry sealed-bearing aftermarket equivalents that outlast the original in the wet Olympia climate, particularly on west-facing doors where morning condensation sits in the track. Servo Garage Doors Olympia is an independent service provider, not affiliated with Genie.

Signs Your Genie Roller Replacement Is Failing

Technician performing professional garage door spring repair and maintenance
Signs Your Genie Roller Replacement Is Failing
  • Grinding or squealing during open/close cycles. The roller bearings have dried out or lost their seal. In Olympia’s damp fall and winter, moisture gets past worn seals and washes out the grease, leaving metal-on-metal contact that you hear before you see.
  • Door shudders or binds at the transition from vertical to horizontal track. A seized roller can’t pivot through the radius curve. The opener strains, the door jerks, and the track takes lateral load it wasn’t designed for.
  • Visible roller wobble or the wheel sitting crooked in the track. The stem has bent or the wheel hub has cracked. This happens when a door gets bumped, or when a seized roller gets forced through hundreds of cycles until it fatigues.
  • Door hangs lower on one side when fully open. One or more rollers on that side have failed and the door section is sagging on the hinge. Left alone, this twists the panel and stresses the lift cables unevenly.
  • Roller has popped completely out of the track. The stem has broken at the shaft or the roller bracket has spread. This is the end-stage failure. The door is now partially unsupported and should not be operated until repaired.
BeforeBefore
AfterAfter

Replacement Cost & What’s Included

Service Price Range (Olympia)
Single roller replacement $110-$160
Multiple roller replacement (3-10 rollers) $160-$220
Track inspection and alignment check Included with roller work

The $110-$220 range covers parts, labor, and the documented photo record. A single failed roller on a lightly used door hits the lower end. Four or more rollers on a heavier Intellicore door, or a door that’s been binding long enough to distort the track, runs toward the upper end. We quote the exact count and price before touching anything, per Clause 1 of The Haven Standard. The Done Right Promise covers the work. Roller replacement itself is not high-tension work, but the door is under spring load during the swap, which is why we don’t recommend full DIY on this.

DIY or Call Us?

Technician checking garage door track alignment with a level
DIY or Call Us?

You can safely inspect your own rollers with the door closed and the opener disconnected. Look for cracked wheels, bent stems, or rollers sitting at an angle. What you should not do is remove multiple rollers from a door that’s still under torsion spring tension. The door can shift in the track, bind, or drop a section. The spring system is under substantial load and is not a homeowner repair.

We carry 2-inch and 3-inch nylon and steel rollers on hand, stem lengths from 4-inch through 7-inch, and we match them to your door on-site. Call (360) 995-1547 and we’ll quote the count and price before we roll. Name the part, quote the number, then do the work.

Get the price in writing before anything starts.Serving Pasadena - a real person answers, day or night.
Call now

FAQs

Ready to get started? Free estimates · same-day response in Pasadena
Call (970) 536-1724

What happens when you call

  1. 1
    A real person answersNo phone trees. Talk to a local garage door pro.
  2. 2
    You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
  3. 3
    A background-checked tech heads outLicensed & insured, typically the same day.
  4. 4
    You approve before work beginsNothing starts until you say go.

What Pasadena Customers Say

★★★★★ 5.0 from 3+ reviews

"Opener had been stalling for months. The tech showed me the logic board reading, replaced the board instead of the whole unit, and it cost a third of the other quote I had."

- Robert K.

"They sent a photo of the snapped torsion spring before quoting anything. Price on the estimate was the price on the invoice. I have never had that happen with a home repair."

- Dana W.

"Text came through with the technician name and photo twenty minutes before he arrived. Small thing, but I stopped worrying about who was at the door."

- Priscilla M.

How It Works in Pasadena

Getting your garage door handled is simple and fast.

1

Call or Request a Free Estimate

Tell us about your garage door needs and we provide an upfront, transparent quote with no obligation and no hidden fees.

2

Licensed Technician Dispatched

A background-checked, certified technician arrives in Pasadena - typically within 30-60 minutes.

3

Problem Solved, Guaranteed

We complete the job to your full satisfaction, backed by our warranty and 100% satisfaction guarantee.

Current Offers

Bring these savings to your next appointment.

10%

10% Off Your First Service Visit

Valid on your first completed service visit with us.

Expires Mar 31, 2027
Always

Written Price Before Any Work Starts

Expires Mar 31, 2027
Free

Free Second Opinion on Any Written Estimate

Expires Mar 31, 2027
Included

Documented Photo Record on Every Visit

Expires Mar 31, 2027

Request a Free Estimate

Tell us what's going on in Pasadena. We'll get back to you fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch
Areas We Serve
Call Now - 24/7 Dispatch